Alveolar bone changes around maxillary incisors after intrusion and retraction with controlled tipping versus bodily movement : A retrospective cone-beam computed tomography study.

OBJECTIVE: To compare the effect of maxillary incisor intrusion and retraction with controlled tipping (CT) versus bodily movement (BM) in extraction cases on alveolar bone height and thickness, using cone-beam computed tomography (CBCT). Correlations between changes in alveolar dimensions and crown or root retraction, incisor inclination, and intrusion were also investigated. MATERIALS AND METHODS: In all, 144 incisors of 36 women were retrospectively evaluated. All patients were treated with anterior intrusion and retraction with either controlled tipping (CT) (group 1) or bodily movement (BM) (group 2). CBCT scans were taken before and after retraction and intrusion and measurements of alveolar bone height and thickness at the level of mid-root and root apex were measured. The prevalence of dehiscence was also calculated. RESULTS: Labial bone thickness (BT) increased at the level of the root apex with increased total BT in the CT group (p < 0.05). The BM group showed decreased palatal BT. Significant vertical bone loss with an increased incidence of dehiscences occurred on the palatal side in both groups. Changes in palatal bone area was negatively correlated with the amount of root apex retraction, while the total BT at the level of root apex was positively correlated with amount of intrusion. CONCLUSIONS: Bodily retraction can result in reduced palatal bone dimensions and an increase risk of iatrogenic sequelae following anterior retraction in extraction cases. Vertical bone loss and an increased incidence of dehiscences is to be expected following anterior retraction. Careful attention must be paid to the bone boundary conditions to avoid moving the incisors out of the alveolar housing.

Using the Dermal Fat Graft as a Barrier Membrane in Unilateral Alveolar Cleft Grafting: A Randomized Clinical Trial.

INTRODUCTION: Alveolar cleft grafting is a surgical procedure that usually suffers from inferior results. METHODOLOGY: The patients were divided into 2 groups; study and control. In the study group, the grafted site was covered with a dermal fat graft. RESULTS: Showed that the bone fill percentage (Bergland Scale) recorded in the study was significantly better ( P =0.03); the study group had 14 successful cases out of 18 compared with the control, which had only 9 out of 20. The study group significantly ( P = 0.002) better bone fill (71%±32%) compared with the control (46%±33%). There was a significant reduction in dehiscence in the study compared with the control ( P =0.02); the study group had no dehiscence compared with the control, which had 5 dehiscence. CONCLUSION: The dermal fat graft use as a barrier membrane was successful in improving alveolar cleft grafting.

Treatment algorithm for velopharyngeal dysfunction in patients with cleft palate: a systematic review.

The aim of this study was to review current literature regarding the speech outcome of different techniques of surgical treatment of VPD in cleft patients, in an attempt to reach a treatment algorithm. A systematic review was done, by searching Pubmed, Scopus, and Web of Science electronic databases, following the PRISMA guidelines. Articles reporting speech assessment results of secondary VPI surgeries on non-syndromic patients with CP. Surgical techniques were categorised into two groups; palatal and pharyngeal surgeries. Raw data were extracted to compare speech outcome and complication of each technique, with special emphasis on the factors affecting the patients' selection for each technique. Our results showed comparable success and complication rates among these techniques. However, the factors governing selection of each technique were identified and taken into consideration to reach a preliminary algorithm. A preliminary treatment algorithm is described based on the results of our review; the most important factors affecting the technique choice are: VP gap size, LVP position, palatal mobility, palatal scarring, VP closure pattern, and age of the patient.

A rare complication of hemolacria after Le fort I osteotomy: a case presentation.

BACKGROUND: Nasolacrimal duct obstruction (NDO) is a common pathology preventing the proper drainage of the tears, and its main symptom is epiphora. Secondary acquired nasolacrimal duct obstruction (SANDO) can be due to a variety of causes including infection, trauma, or neoplasms. It has been reported to occur with different forms of maxillofacial trauma, especially Le Fort II, Le Fort III, naso-orbital-ethmoidal, and orbital floor fractures. CASE PRESENTATION: A 20-year-old Egyptian female presented to correct a facial disharmony due to a cleft lip and palate defect. The patient reported a history of congenital NDO and had deficient lateral nasal walls. Bimaxillary surgery was planned, including a Le Fort I osteotomy for the maxilla and bilateral sagittal split osteotomy for the mandible. The surgery was uneventful, but the patient complained from bloody tears or hemolacria few days postoperatively. This complication began to cease spontaneously after 2 days and completely recovered after 4 days. CONCLUSION: Hemolacria is an infrequent finding after maxillofacial surgeries and may be associated with CLP surgeries more than other surgeries. In this case, it was easily managed, and surgeons should be more aware of it to try to prevent its occurrence.

The Use of Computer-Guided Half Propeller Genioplasty for the Correction of Mandibular Asymmetry (A Mandibular Orthognathic Surgery Without a Condylar Intervention Technical Strategy).

INTRODUCTION: Mandibular asymmetry is a facial deformity that results from multiple causes; among these are growth deficiency like hemifacial microsomia and growth excess as in condylar hyperplasia. The facial asymmetry caused by condylar hyperplasia has been treated over the years with different surgical and nonsur-gical modalities dependent on the age of the patient and the severity of the condition. The authors in this article introduce a modified version of the propeller genioplasty technique. MATERIALS AND METHODS: A new surgical technique "modified propeller genioplasty" is introduced for the management of facial asymmetry. Virtual surgical planning of the osteotomies and segment repositioning was done virtually. A cutting guide, positioning guides and 3D model of the corrected chin were 3D printed, to facilitate replication ofthe virtually planned osteotomies, prebending of plates, and segment repositioning. RESULTS: The esthetically accepted result was achieved using this technique with minimal postoperative complications. CONCLUSIONS: The technique appeared to be accurate, simple, and more cost efficient when compared to patient-specific plates.

A Systematic Review to Uncover a Universal Protocol for Accuracy Assessment of 3-Dimensional Virtually Planned Orthognathic Surgery.

PURPOSE: The aim of this study was to systematically review methods used for assessing the accuracy of 3-dimensional virtually planned orthognathic surgery in an attempt to reach an objective assessment protocol that could be universally used. MATERIALS AND METHODS: A systematic review of the currently available literature, published until September 12, 2016, was conducted using PubMed as the primary search engine. We performed secondary searches using the Cochrane Database, clinical trial registries, Google Scholar, and Embase, as well as a bibliography search. Included articles were required to have stated clearly that 3-dimensional virtual planning was used and accuracy assessment performed, along with validation of the planning and/or assessment method. Descriptive statistics and quality assessment of included articles were performed. RESULTS: The initial search yielded 1,461 studies. Only 7 studies were included in our review. An important variability was found regarding methods used for 1) accuracy assessment of virtually planned orthognathic surgery or 2) validation of the tools used. Included studies were of moderate quality; reviewers' agreement regarding quality was calculated to be 0.5 using the Cohen κ test. CONCLUSIONS: On the basis of the findings of this review, it is evident that the literature lacks consensus regarding accuracy assessment. Hence, a protocol is suggested for accuracy assessment of virtually planned orthognathic surgery with the lowest margin of error.